NOTE: Remove power from the
pedal before plugging/un-plugging
from the external tap/exp jack.
For Expression, move switch 1 down
and 2 and 3 up. For tap, move switch
1 up and 2 and 3 down.
Input/Output: The pedal can operate in multiple configurations. Mono In/Mono Out,
Mono In/Stereo Out, Stereo In, Stereo Out. In order to take full advantage of the stereo
feature set, it is recommended to run the pedal in Mono In/Stereo Out or Stereo In/Stereo
Out.
TAP/EXP: This input jack can allow you to connect an external tap tempo control or an
expression pedal. Operation of this jack is determined via an internal dip switch. Access
by removing the pedal’s backplate. For an external tap tempo you will need to use a 1/4”
TS Cable with a normally-open switch. For an Expression Pedal, you will need to use a 1/4”
TRS Cable.
With an external expression pedal connected to the
pedal, you can have full control over every parameter on
the pedal.
To assign a control(s) to the expression pedal, when the
pedal is active, hold down the bypass switch, you are now
in expression edit mode. While holding down the bypass
switch, you can turn any control (or press the tap division
switch) and it will be assigned to expression. Multiple
parameters can be assigned at one time.
RESET EXPRESSION CONTROLS: While in expression
edit mode, press the tap tempo switch one time in
order to return to the default expression controls.
(If you press the tap tempo switch once, and do
not choose a different parameter to control, the
pedal will default to control RATE via the
expression pedal).
NOTE: Each expression pedal is different, so
the available range of control may differ from
expression pedal to expression pedal.
eXpReSSION