Tool Operation – for Sausage Bag Application
1.
Cut a hole in one end of the sausage bag as shown in the figure below.
2. Remove the front cap. Fit the nozzle inside the front cap and cut off the tip at a point suitable for the
job.
3. Insert the sausage bag into the compound holder. Screw the front cap on tight. It is not necessary to
pull back the rack by hand. Make sure the sausage bag is inserted properly and sits up tight on the
plastic plunger disk.
4. Push the Rear Knob forward gently to force the rack to tighten behind the sausage bag.
Plastic Plunger Disk
Approx. 2cm across
Front Cap
Nozzle
Plunger Disk
