Operating Instructions
WXR720/L, WXR740/L
Trailer Wood Splitter
30
6.14 Transporting
6.14.1 Prepare for Transport
•
On WXR740 Series splitters, make sure the pivoting main
frame is fully lowered to horizontal. The lock pin in the
pivoting splitter beam must be fully engaged.
00624
Fig. 29 –
Lock Pin Fully Engaged on WXR740 Series
•
Turn the fuel OFF when transporting.
00278
Fig. 30 –
Fuel Valve OFF
•
Clean all debris from the splitter that could fall off in
transport.
•
Check tire pressure. Inspect for cuts or damaged rims.
•
Check lug nuts and re-torque as necessary. Inspect again
after 20–25 mi (32–40 km). Check weekly. See
•
Inspect and replace any axle dust caps that are missing,
damaged or leaking.
•
Always be in compliance with all applicable local
regulations when transporting.
6.14.2 Connecting a Tow Vehicle
1.
Keep bystanders are clear of the machine.
2.
Make sure there is enough room and clearance to safely
back up to the machine.
3.
Slowly back the tow vehicle until the coupler on the hitch
and ball are aligned.
00207
Fig. 31 –
Ball Hitch Aligned
WXR720 Models
4.
Lift the hitch and place the coupler over the ball on the
hitch.
5.
Flip the latch to lock the coupler around the ball.
6.
Pull out the jack stand snap lock pin and raise the jack
stand to its stowed position. Install snap lock pin to secure
it.
WXR740 Models
7.
Raise the rear jack stand and secure with the snap lock pin.
All Models
8.
Cross safety chains under trailer tongue and attach
securely to the tow vehicle hitch.
9.
Connect the wiring harness for the lights (as equipped).
10.
Reverse the above procedure when unhooking.
Summary of Contents for WXR720
Page 44: ...www wallensteinequipment com...
