Wallenstein WXR720, Operator'S Manual

Page: 21 / 44

WXR720/L, WXR740/L
Trailer Wood Splitter
Controls
21
00713
1
2
4
3
3"
(8 cm)
N
Fig. 32 – Stroke Limiter Adjustment
5.3 Stroke Limiter Accessory
Use the Stroke Limiter accessory to shorten the cylinder return
time. Shortening the return stroke improves productivity.
Setting Stroke Limiter
1. Place a typical sized log on the splitter bed.
2. Move the push block up to the log, stopping 3" (8 cm)
away.
3. Shut off the engine. Make sure the control valve lever is in
the neutral position.
4. Loosen the hex set screw on the rod adjusting collar and
move the rod up to the push block. (This is the set position
at which the push block stops on the return cycle.) Tighten
the hex screw.
Test the set up by cycling the push block through its path.
Split a log then put the hydraulic lever into the return (detent)
position. The lever should trip the hydraulic control and the anvil
/ ram stops at the set position. Adjust as required.