Service and Maintenance
WXR720/L, WXR740/L
Trailer Wood Splitter
36
Procedure
1.
Place a drain pan under the filter head.
2.
Remove the oil filter. An oil filter wrench may be required.
3.
Apply a light coat of clean oil to the seal and install the new
filter. Tighten by hand only.
4.
Run the machine for 1–2 minutes operating the cylinder.
Check filter head for oil leaks.
5.
If a leak is found, shut off the machine and correct it.
6.
Check hydraulic reservoir oil level. Top up as required.
7.
Dispose of spilled oil in an environmentally safe manner.
8.7 Engine Air Cleaner
Check air filter every 50 hours of operation. Change air filter
elements at 100 hours of operation or annually.
NOTE: Refer to the engine manual for information on
servicing the air cleaner.
A dirty air filter can restrict air flow to the carburetor, reducing
engine performance. If the engine is operated in very dusty
areas, clean the air filter more often than specified
.
IMPORTANT! Operating the engine without an air filter, or
with a damaged air filter, can allow dirt to enter the engine,
causing rapid engine wear. This type of damage is not
covered by Warranty.
Inspection
Remove the air cleaner cover and inspect the filter elements.
Clean or replace dirty filter elements. Always replace damaged
filter elements.
00202
Fig. 37 –
Engine Air Cleaner
8.8 Electrical System – General
(As equipped)
IMPORTANT! When assembling or replacing wire
harnesses, apply a thin coating of silicone dielectric grease
to the harness connectors.
Clean off any corrosion or loose particles, then apply a
small amount to the surfaces of the connectors where they
meet. The grease helps to stop any possibility of future
corrosion.
Reassemble the connection. Wipe off any grease that
squeezes out.
Summary of Contents for WXR720
Page 44: ...www wallensteinequipment com...
