Wallenstein QC605, Operator'S Manual

Page: 20 / 38

Familiarization
QC605 / B, QC620
Skid Steer Mounted Backhoe
20
3.3 Replace Damaged Safety Signs
• Keep safety signs clean and legible at all times.
• Replace safety signs that are missing or have
become illegible.
• Parts that were replaced with a safety decal on
them must have the safety sign replaced.
• Replacement safety signs are available from your
authorized Distributor or Dealer Parts Department
or the factory.
3.4 How to Install Safety Signs
Installation area must be clean, dry, and free of grease
or oil.
Ambient temperature must be above 50 °F (10 °C).
Determine exact position before removing the backing
paper.
1. Peel back the corner of the backing paper.
2. Align the sign over the specified area and carefully
press the small portion with the exposed sticky
backing in place.
3. Slowly peel back the remaining paper and carefully
smooth the remaining portion of the decal.
4. Small air pockets can be pierced with a pin and
smoothed out using the piece of sign backing
paper.
4. Familiarization
Wallenstein QC600 Series backhoes are light-duty
machines that attach to a skid steer. They can be used
for all light duty digging, trenching, and excavating.
4.1 To the New Operator or Owner
It is the responsibility of the owner or operator to read
this manual and to train all other operators before
they start working with the machine. Follow all safety
instructions. Untrained operators should not be allowed
to use the machine.
Many features incorporated into this machine are the
result of suggestions made by Wallenstein customers.
Read this manual carefully to learn how to use the
backhoe safely. Following the instructions in this
manual along with a good maintenance program can
provide many years of trouble-free service.
IMPORTANT! Make sure all operators
understand how to put the machine in a Safe
Condition before servicing or repairing. See Safe
Condition on page 12 .
4.2 Operator Orientation
IMPORTANT! The directions for left-hand,
right-hand, backward and forward as mentioned
throughout this manual, are determined when
sitting in the operator's seat facing the direction
of forward travel.