7.4 Skidding Logs
•
Position the grapple over the end of the log, a foot (25 cm)
or so from the end.
•
Lower the grapple onto the log and close the forks around
it.
•
Raise the grapple and move on to the next log or begin
skidding. Carry the load as low as possible for better
visibility and stability.
01529
Fig. 24 –
Skidding
7.5 Right Angle Lifting
•
Determine where the center of the load is in order to pick
it up safely. The stump end of logs can be heavier and the
smaller ends lighter. Balance loads carefully.
•
Make sure grapple forks have full contact with all the pieces
you are lifting. Otherwise the load could become unstable
causing a dangerous situation.
01532
Fig. 25 –
Lifting
7.6 Parallel Lifting with Cantilever
Cradle
•
Position the grapple cantilever over the end of the log.
•
Lower the grapple and drive the skid steer slightly into the
log end. Close the grapple forks until there is a good grip on
the log.
•
Raise the grapple to carry the log.
01530
Fig. 26 –
Parallel Lift with Cantilever
LXG400 Series
Log Grapples
Operating Instructions
33
