BX52R, BX72R, BX102R
3 PH Roller-feed Chipper
Controls
33
5.9.4 Menus
Main screen
The
Main
screen is the default screen with the ignition key in the
ON position. Pressing the key below
Home
icon in any sub
menu takes you back to the Main screen.
If the display is left unattended for a period (approximately 60
seconds), the system returns to the Main screen.
The
Main
screen displays:
•
Feed Position (feed roller rotation direction)
•
Rotor Speed (rpm)
•
Hours (rotor hours of operation)
•
Settings Icon
1. Feed Position
Feed roller drive position is displayed with colored icons to
indicate direction.
REVERSE
REVERSE (red arrows) – feed rollers are
reversing. Material in the rollers is being
pulled back away from the rotor.
NEUTRAL
NEUTRAL (amber) – feed rollers are stopped.
FORWARD
FORWARD (green arrows) – feed rollers
are going forward. Material in the rollers is
pushed into the rotor.
LOW RPM
LOW RPM (green arrows) – with the feed
control bar in Forward, feed rollers are not
moving because rotor RPM is too low for
chipping. Once engine speed is increased
above the minimum start speed, FORWARD is
displayed.
2. Rotor Speed (rpm)
Displays the speed (revolutions per minute) the rotor is
turning. A value of 0000 indicates the rotor is not turning.
3. Hours
Counts the total operating hours of the rotor. This value
is not resettable. (Engine hours are displayed on the hour
meter beside the ignition key. Use Engine Hours as a
service interval guide.)
4. Settings
Press the soft key button below
Settings
icon to
navigate to the
Settings
screen.
0:00 HOURS
ROTOR SPEED
FEED POSITION
NEUTRAL
RPM
0000
01248
1
2
3
4
Fig. 45 –
Main Screen
