Service and Maintenance
BXS Series
3PH Self-feed Chipper
38
Adjusting – All other models
(BX52S shown. Other models similar.)
2
3
1
01370
Fig. 47 –
Adjusting Ledger Knife
1. Securing Bolts
2. Jam Nuts
3. Adjusting Nuts
1.
Loosen the securing bolts (1).
2.
Loosen the jam nuts on the outside of the ledger knife
support (2).
3.
Turn the adjuster nuts (3) clockwise so the ledger knife
slides firmly up against the gauge inside the rotor housing.
Move both adjusters evenly.
4.
Remove the ledger knife gauge. Tighten the jam nuts.
Tighten the securing bolts.
Changing Ledger Knife
(BX52S shown. Other models similar.)
Procedure
Remove the securing bolts to remove the ledger blade.
01372
Fig. 48 –
Changing Ledger Knife
5.
Rotate the ledger knife or replace it with a new or
sharpened knife.
6.
Hand-tighten the bolts.
7.
Verify clearance before tightening. See
.
