Service and Maintenance
BXS Series
3PH Self-feed Chipper
32
8. Service and Maintenance
• Follow good shop practices:
-
Keep service area clean and dry.
-
Be sure electrical outlets and tools are properly
grounded.
-
Use adequate light for the job at hand.
• Never operate the tractor engine inside a closed building.
The exhaust fumes may cause asphyxiation.
• Place machine in a Safe Condition before servicing or
.
• Allow the machine to cool before performing
maintenance. Components and oil may be hot enough to
cause burn injury.
• Never work underneath equipment unless it is blocked
securely.
• When performing any service or maintenance work
always wear proper PPE for the job.
• Where replacement parts are necessary, genuine factory
replacement parts must be used to restore equipment
to original specifications. The manufacturer is not
responsible for injuries or damages caused by use of
unapproved parts or accessories.
• Inspect and tighten all bolts, nuts and screws. Check
that all electrical and hydraulic connections are properly
secured to ensure chipper is in a safe working condition.
• After completing a service procedure, make sure all
covers and shields are reinstalled.
• When cleaning any parts, do not use gasoline or diesel
fuel. Use a regular cleanser.
• Always use proper tools in good condition.
WARNING!
Risk of serious personal injury. Stop engine
before performing ANY service or maintenance
procedure. Reinstall all covers and shields
removed before putting machine back into
service.
W033
WARNING!
Shut down the machine and allow it to cool
before performing any service, maintenance, or
inspection procedure. Engine components and
oil may be hot enough to cause injury.
Make sure the machine is in a Safe Condition to
work on. Review Maintenance Safety beforehand.
W041
Safe Condition
1.
Lower the chipper to the ground.
2.
Disengage the PTO.
3.
Set the parking brake and turn off the tractor engine.
Remove the ignition key.
4.
Make sure all components have stopped moving.
5.
Block and chock the tractor wheels.
6.
If required, set the rotor lock..
8.1 Grease Type
Use an SAE multi-purpose high temperature grease with
extreme pressure (EP) performance. Also acceptable is an SAE
multipurpose lithium-based grease.
