10
6
INSTALLATION.
6.1
GENERAL CRITERIA FOR THE SITE
The charging station was constructed for the indoor and outdoor area. Accordingly it is
necessary to ensure the installation conditions and the protection of the device at the
installation area.
•
Follow the local regulations for electrical installations, fire prevention and accident
prevention, as well as emergency exits at the location
•
The charging station must not be installed in potentially explosive zones (Ex
environment).
•
Build the charging station so that it is not located in the direct flow of passersby and
so that no one can trip over connected charging cables and so that the charging
cables do not cover or cross passing pedestrian and motorized traffic.
•
Do not install the charging station at locations where it is exposed to ammonia or
ammonia gas (e.g. in or at stables).
•
The installation surface must be sufficiently stable in order to withstand the
mechanical forces.
•
Do not install the charging station at locations where falling objects could damage
the device (e.g. hung up ladders or automobile tires).
•
According to the product standard, the charging station must be located at a height
between 0.4 m and 1.5 m. We recommend install the charging station (height of the
socket or parking bay) at a height of 1.2 m. Observe that national regulations can
limit this height. It must be taken in consideration that, in the case of placement in
parking, put it at a height, which in case of accidental collision, does not damage the
recharging point.
•
The device must not be exposed to direct spray water (e.g. neighboring manual car
wash facility, highpressure cleaner, garden hose..).
•
The device should be protected against direct rain as far as possible to prevent icing,
hail damage or similar.
•
The device should be installed so protected from direct sunlight as far as possible to
prevent reduction of the charging current or interruption of the charging due to
excessive temperatures of the charging station components.
•
When set up unprotected against the weather (e.g. outside at a parking space), the
charging current specification is reduced to 16 A if the maximum permitted
temperature is exceeded. We strongly recommend to switched off the device.
Observe the internationally valid installation standards (e.g. IEC 60364-1 and IEC 60364-5-52)
and comply with the nationally applicable installation standards and regulations.
6.2
INDICACIONES PARA LA CONEXIÓN ELÉCTRICA GENERALIDADES
EV Portable is designed for plug it in a CEE Industrial connector (female). You need to choose
the amps rate depending on the place where it is installed and the adaptor selected.
EV Portable needs to be connected to a main supply line and must be hardwired and
correspond to the nationally applicable legal conditions.
Selection of the RCD circuit breaker:
•
Each charging station must be connected to a separate RCD circuit breaker. No other
circuits may be connected to this RCD circuit breaker.
