3
Step 2 - Bookcase Assembly
Start the cabinet assembly by using either one of the Bookcase End Panels and fixing it to the
Back Panel. Note: The cam locks are not facing what will be the inside of the Bookcase when
built.
Back Panel - Place the Bookcase Back Panel onto the End Panel. Match up the cam locks with
the cam pins. Tighten the cam locks and cam pins together by using a Phillips head hand
screwdriver.
Bottom & Bottom Panels - With the cam locks facing away from the inside of the Bookcase
attach the Bottom Panel to the End Panel and Back Panel. Repeat this process with the Top
Panel.
Place the remaining End Panel on top of the previously assembled panels. Ensuring the cam pins
are lined up with the cam locks. Tighten the cam pins to the cam locks.
Tip:
You may need to lightly tap the cam pins into the cam locks with a rubber mallet. Ensure
you do this where the cam pins are. Failure to do so may result in damage to the End Panel.
Step 3 - Fixing Bookcase to the Wall Bed
Attaching to the wall bed - Place the cabinet next to the side of the Wallbed. Check that the
bookcase end panel is flush with the front edge of the wall bed End Panel. Attach the Bookcase
to the wall bed cabinet by using the 28mm wood screws supplied. (two towards the top of the
Bookcase and two at the bottom)
Note: These holes will need to be pre-drilled using a 5mm drill bit. Use caution not to drill
through to the inside of the wall bed End Panel.
Caution:
Do Not over tighten the wood screws into the side of the wall bed End Panel as it may
end up protruding through the opposite side of the panel.
Attaching the Fixed Shelf - Insert the shelf, so the cam locks and cam pins are interlocked and
then tighten the cam locks using.
IMPORTANT SAFETY INFORMATION
All WallBeds Australia Bookcases and Cabinets must be securely attached to the WallBed before
use. Ensure that children DO NOT climb or hang on any part of the Bookcase Or Cabinet.
Failure to do so may result in personal injury.
Removing Panel Stickers/Labels
Remove once installed, heat up with hairdryer & then to remove any sticky residue use wax and
grease remover or similar.
Avoid using a razor blade as you may damage the cabinetry.
©2019 WallBeds Australia
