•
Place the Drawer Cabinet unit next to the side of the Alpha Wallbed that it will be attached to.
Ensure the front edge of the drawers are flush with the front edge of the wall bed cabinet.
•
Place the bookshelf unit on top of the drawer cabinet unit and line up the front of the bookcase
bottom panel with the front edge of the drawer.
•
Check that the bookshelf end panel is also flush with the front edge of the wall bed cabinet end
panel.
You will need to pre-drill the 5mm screw holes.
When attaching the Pull Out Drawer / Table unit to the bookshelf.
•
Remove the pull out drawer / & pre-drill a 5mm hole up through the top panel of the pullout
drawer unit into the bottom panel of the bookshelf. Do one towards the front and then one
towards the back of the unit.
IMPORTANT - Use caution not to go all the way through to the
bottom panel of the bookcase.
Attach together using the 28mm screws supplied.
•
Using an existing shelf pin hole, fix the bookshelf to the side of the bed cabinet by using the
28mm wood screws supplied.
8
Step 2 - Bookcase Assembly
Start the Bookcase assembly by using either one of the Bookcase End Panels and fixing it to the
Back Panel. Ensure the cam locks on the Back Panel are not facing what will be the inside of the
Bookcase when built.
Back Panel - Place the Bookcase Back Panel onto the End Panel. Match up the cam locks with the
cam pins. Tighten the cam locks and cam pins together by using a Phillips head hand
screwdriver.
Top
& Bottom Panels - With the cam locks facing away from the inside of the Bookcase attach
the Bottom Panel to the End Panel and Back Panel. Repeat this process with the Top Panel.
Place the remaining End Panel on top of the previously assembled panels. Ensuring the cam pins
are lined up with the cam locks. Tighten the cam pins to the cam locks.
Tip:
You may need to lightly tap the cam pins into the cam locks with a rubber mallet. Ensure you
do this where the cam pins are. Failure to do so may result in damage to the End Panel.
Step
3
– Fixing
both
Unit
s
together and
to
the
Alpha
Wall
Bed
Removing Panel Stickers/Labels
To remove once installed, heat up with hair dryer & then to remove any sticky residue
use wax and grease remover or similar.
Avoid using a razor blade as you may damage the cabinetry.
IMPORTANT SAFETY INFORMATION
All WallBeds Australia Bookcases and Cabinets must be securely attached
to the WallBed before use. Ensure that children DO NOT climb or hang on
any part of the Bookcase or Cabinet.
Failure to do so may result in personal injury.
©2019 WallBeds Australia
