40D
6 / ENGLISH
490001
Use on a Basic
Control Panel
Heating
The heater starts
automatically when the
power switch is turned to
HEAT position. First there is
a testing phase during which
the yellow and red lamps
blink in turn. Then the yellow
power indicator lamp will
light up and the actual
ignition begins. The ignition
takes about 5 minutes during
which the red heating lamp
will light up. The heating
lamp is lit when the
combustion has smoothened
in the burner. After the
ignition the heater can be
adjusted with the control
panel.
The heater will not
necessarily start at first after
the installation when the fuel
hose is empty. Then the
combustion light starts to
blink after the start-up. Turn
the power switch to OFF
position. The heater cannot
be restarted until the cooling
has been completed and all
indicator lamps have gone
out. Once the indicator
lamps have gone out, restart
the heater by switching it to
HEAT position.
Turn the power switch to
OFF position to switch off
the heater. The cooling of the
heater takes about 10
minutes after switch-off.
During cooling the power
lamp is lit, and the red
heating lamp blinks. After
cooling all indicator lamps
go out.
Ventilation
Turn the power switch to
VENT position to start
ventilation. Both the yellow
power indicator lamp and
the green ventilation
indicator lamp light up
immediately. The efficiency
of the ventilation air flow can
be adjusted with the power
adjustment knob. Turn the
power switch to OFF
position to stop ventilation.
USE
Figure 11: Basic Control Panel 3004
Power switch
Power adjustment
Heating indicator lamp
Ventilation indicator lamp
Power indicator lamp
