AIR BOOST
Use
Arrow Buttons
to move the selector
to the
Air Boost
icon
and press the
Select
Button
.
The orange Air Boost
On icon will appear.
Ventilation Mode blows fresh air without
heating with 6 blower speeds. Choose
Ventilation Mode prior to starting the heater.
VENTILATION MODE
Pause Mode automatically turns the heater off if the
temperature r2 C (3 F) above the set level
for 1/2 hour due to local ambient conditions.
Pause Mode can be turned off temporarily by slightly
increasing the target temperature.
PAUSE MODE
If the heater is in Pause Mode,
Paused and a
Pause Icon
will appear
on the screen.
Heater will re-start heating again
automatically, if the cabin
temperature falls 2 degrees C (3 F)
below the set target temperature.
Air Boost feature maximizes the air volume for quick
defrosting and drying, but does not change the set
temperature. Air Boost can be activated either in Manual
or Thermo Control Mode, when the system is heating.
To go back to normal
air volume, choose
the
Air Boost
icon
again and press the
Select Button
. The
Air Boost icon will
change back to white.
Use the
Arrow Buttons
to move
the selection square to the
Main
Menu Bar
and press the
Select
Button
to activate it.
Use
Arrow Buttons
to choose
Ventilation Mode
and press the
Select Button
.
Move the selection square to the
Start/Stop Icon
and press the
Select Button
once. Press the
Select Button
down again for 3
seconds to confirm and start the
heater. Yellow Power On light
will appear in the Info Bar.
Choose the blower speed
(1-6) by moving the selection
square to the
Blower Speed
and
press
Select Button
to activate
the field.
Press
Arrow Buttons
to set the
desired power and press the
Select Button
to choose.
To deactivate ventilation, turn
the heater off. Re-start in the
desired mode.
(IN THERMO CONTROL MODE)
If a
Lock Icon
is displayed, the
heater has locked itself for safety.
The heater will also lock after 2
unsuccessful starts. Move the
selection square to the
Exclamation Point Icon
and press
the
Select Button
. An Error Page
will appear.
LOCK
If the heater has locked itself,
there may have been a failure
that should be investigated and
resolved prior to further use. The
error page will display a check list
and a website for further
information. If you need help,
reach out to a professional.
(SAFETY FEATURE)
Press and hold the
Select Button
down for more than 4 seconds.
Stopping will appear and the
Power Icon light will change to
white indicating the unit is off.
SHUTDOWN
Note: The system mode that was used last upon
shutdown will be the same mode when the heater
is turned on again.
To remove the lock, press any
button to return to the main display.
Move the selection square to the
Main Menu Bar
and press the
Select Button
,
choose
Settings,
and
press the
Select Button
. Choose
Clear Lock
from the Settings Menu
and press the
Select Button
.
Select
Button
All rights reserved. Wallas-Marin reserves the right to change or improve its products and to make changes in the content of this guide
without obligation to notify any person or organization of such changes or improvements. Go to www.wallas.com for current updates and
supplemental information concerning the use of this product.
