K00144
- 79 -
25
27
19
18
20
16
27
26
23
24
11
21
24
15
21
11
22
17
22
en
Installation
Fuel lines & tank connection
•
The fuel tank (17) must be placed
so that it always - also under
heeling lies below the heater bot-
tom level.
•
The tank vent tube (22) end must
be taken so high that fuel from
tank is not spilled out in the ves-
sel when it heals.
• The
tank
fi lter (16) must abso-
lutely be mounted at the end of
the fuel suction tube in the tank to
shield the pump against impurities
and water and to hold the suction
tube down pressed.
•
The tank connector (15). The black return tube
(11) and transparent suction tube (21) are taken
through the connector pipes and secured with
rubber sleeves (24). The tubes are thereafter cut
to suitable length, the suction tube straight off.
The suction fi lter (16) is mounted at the suction
tube end with nut (18), rubber ring (19) and plastic
shield washer (20).
•
Excess fuel return tube (11), Ø 5/3 mm, polyamid,
black.
•
Fuel suction tube (21), Ø 5/2 mm, polyamid, trans-
parent.
•
Tank vent tube (22), Ø 7/5 mm, PVC.
•
Rubber sleeves (24) securing the fuel tubes.
•
Tank connector-take through plate (25).
•
Tank connector screw collar holder (26).
•
Rubber gasket ring (23).
• Tank
fi lter (16).
•
Filter holder nut (18).
•
Filter holder nut rubber ring (19).
•
Filter shield washer ring (20).
•
Shield spiral (27) hinders water intake by holding
the suction end free from tankbottom.
The fuel lines must be placed so that the black excess fuel return
tube has continuous fall toward tank.
Loops upward from airlocks, which hinder the free return of excess
fuel and can cause burning disturbances and shooting.
1800 t / 2400 t
490535
en
