18
www.WalkinPets.com
Assembling Fully Supportive Wheelchair
Video instructions also available:
hpets.net/sfav
Step 1: Length:
Left and Right Extenders (A & B)
Take out existing side extenders on rear wheelchair and replace with
the front wheel extenders. Socket Shoulder Screws (4) will be on the
outside of wheelchair and used to attach leg rings.
Step 2: Height:
Struts and Wheels (C1 or C2)
Insert the struts into the legs, making sure the left and right are on the
correct side.
Step 3: Leg Rings (D)
Install the leg rings (p.10). The straps go over the frame; insert the
black plastic clip on the socket shoulder screw and push upward.
You will hear a click when it is locked into place. Leg rings should
look like two Cs, not two Vs (p.10).
The dog's leg will go inside each ring to support his/her body in
the front. The front leg rings may be lower than the rear Leg Rings to
accommodate the dog's full chest. To remove Leg Rings, put your
thumb in the circle and pull down.
Make sure that all Rs and Ls are on the proper sides.
Step 4: Width:
Adjust width according to your dog's chest (usually the widest area).
