Assembly Instructions
20
Battery Installation
IMPORTANT:
Make sure battery is securely
mounted in the frame. A loose battery may cause
damage to the case resulting in acid leakage and
severe damage to the machine. A hazard may be
created by damage to critical working parts and
safety systems.
Install the battery in the mower as shown in
Battery
Installation
photo. Connect the positive (+) first and
then the negative (-) cable to the proper battery ter-
minal
[red cable and boot connects to the Posi-
tive (+) terminal].
Slide the rubber boot up and over
the battery post, making sure it covers the post com-
pletely
to prevent an electrical short.
WARNING
Make sure the battery cap vents are open.
Improper venting of the battery COULD
cause a battery explosion.
Battery Protector
Plate in Place
Battery Clamp
Secured by
Wing Nut(s)
(+) Battery Cable
Connection
Battery Installation
Mower Deck Assembly
Deck Caster Wheels Installation
1. Remove the bolt, nut, axle spacer tube, and
spacer washers from each deck caster wheel
fork.
NOTE:
Spacer washers are used only when the
optional foamed rubber deck wheels (8 x 3.00)
are installed.
2. Fit the axle spacer tube through the wheel hub,
position the spacer washer on each side of the
hub (if used), and fit the assembly into the wheel
fork.
3. Insert the 3/8-16 x 4-1/2 in. bolt through the
wheel fork with the bolt head to the outside and
install the 3/8-16 in. Keps nut.
4. Tighten the bolt and nut until the axle spacer
tube bottoms against the inside of the wheel
fork (will not turn) while the wheel and spacer
washers (if used) spin freely without binding.
Spacer Washer
Axle Bolt
Axle Spacer Tube
Deck Caster Wheel Installation
5. Grease the caster wheel bearings and caster
pivot bearings - one grease fitting for each
wheel and each pivot.
Summary of Contents for T25i
Page 85: ...81 Operator s Notes...
Page 86: ...82 Operator s Notes...
