E
39
22. Error Codes
This flash is programmed so that in case of
malfunction the LCD display will show diffe-
rent types of errors blinking continuously in
conjunction with the output of the flash.
E1:
Temperature Transducer problem. Turn the
unit OFF immediately and contact the place
where you purchase the flash.
E2:
This error code can display after a long shoo-
ting session at high output or rapid sequence.
Turn OFF the flash and allow it to rest 30
minute
.
E3:
This error code will display when the internal
voltage of the flash is too high. Turn OFF
the power immediately. After a few minutes
turn on the flash again, if you still have the
malfunction warning, turn OFF the unit and
contact the place where you purchased the
flash.
E4:
This error code will display when the charge
circuit is wrong. Turn OFF the unit and con-
tact the place where you purchased the flash.
