MF002XLS
WARNING
！
！
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
Dual Monitor Desk Mount
75x75\100x100
INSTALLATION MANUAL
1-844-SATTLER (18447288537)
www.walielectric.com
RATED
(10kg/22lbs)x2
MAX 27”
TIPOVER WARNING
● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
Supplied Parts List
Lower Pole
a1 (x1)
Monitor Arm
c (x2)
Weighted Base
b (x1)
VESA Plate
d (x2)
Nut
h (x2)
M5x14 Bolt
e (x3)
Support Plate
j (x1)
Spring Washer
l (x1)
M10 Washer
k (x1)
M10 Bolt
i (x1)
Grommet Base Plate
t (x1)
Wire Clip
n1 (x2)
Allen Key
o (x1)
M4 Spacer
s (x8)
M4x30 Bolt
r (x8)
Wrench
p (x1)
M4x12 Bolt
q (x8)
Upper Pole
a2 (x1)
Pole Cover
n2 (x1)
e
a1
o
1a. Install the
Lower
Pole a to the weighted Base b using 3pcs M5x14 Bolts e ,
and tighten with Allen key 3mm o .
2
1b. Optionally, you can drill a 10mm diameter hole in your desk and secure using the
Support Plate , M10 Washer k , Spring Washer and M10 Bolt i . Fasten M10 Bolt with
provided Wrench p .
i
k
j
p
l
i
i
k
j
p
l
a1
b
b
o
e
ø 10mm
(ø
")
3/8
Option A : Weighted Base Installation
1
a2
a2
a1
a1
a1
o
t
n2
o
Option B : 16.3'' Pole Installation (Only Used For Single Monitor Mount)
Option A : 31.5'' Pole Installation
Loosen the screw on the Lower Pole
a1
with Allen key 2mm o . Connect
Lower Pole
a1
to Upper Pole
a2
and tighten the screw with Allen key
2mm o to fix the two poles.
a1
a1
Press Pole Cover into the top of Lower Pole
a1
.
a1
a1
Pre-Assembly
Pre-Assembly
o
a2
o
t
n2
