Manually swivel, tilt, and rotate the monitor for the best viewing angle. Adjust the height of VESA
Plate
A
using Allen Key 6mm
N
.
Guide the cable through the Tool Holder
F
and wire clips. Store the Allen Keys in the Tool
Holder
F
.
For safety, please do not extend the arms too far forward or backward. This may cause
instability and tip over.
3a.Existing Grommet Hole Installation
3b.Self-drilled Grommet Hole Installation
5
10
6
8
7
G
D
0.39”-3”
ø 10mm
(ø ")
3/8
L
B
D
F
N
B
M
N
M4x12
M5x12
Hand thread screws
into the threaded
inserts on the back of
your TV to determine
which screw diameter
(M4x12 or M5x12) to use.
M-C
M-A
M-E
M-E
A
M-E
M-F
M-B
M-D
A
Mark the position of the hole on your mounting surface. Drill a 3/8"(10mm) diameter hole at
the marked position through the mounting surface. Place the Grommet Base Plate
G
and
Pole
D
to the grommet hole. Insert the hand knob through the center hole of Support Plate
L
and desk hole, rotate the hand knob clockwise to fasten for stability.
If the existing grommet hole comes with a plastic protector, remove it to ensure a flat surface
before installing the desk mount. Place the Grommet Base Plate
G
and Pole
D
to the
grommet hole. Insert the hand knob through the center hole of Support Plate
L
and desk hole,
rotate the hand knob clockwise to fasten for stability.
Put the Tool Holder
F
and Arm
B
through the Pole
D
, adjust the preferred height and
tighten using Allen Key 6mm
N
.
Put the assembled TV/Monitor onto the Arm
B
and ensure stability
.
Tighten the VESA plate
using Nut
H
and M3x7 Bolt
I
with a screwdriver. Adjust the tilt angle using Allen Key 6mm
N
.
(Screwdriver not included)
9
0.39”-3”
L
G
D
Step 5.1
Select TV Screws
Step 5.2
Select Spacers ( if needed )
Step 5.3a
Step 5.3b
Select M4x12 Bolt
M-A
or M5x12 Bolt
M-C
according to your TV/Monitor, connect
VESA Plate
A
together with D5 Washer
M-E
into the mounting holes on the back of
TV/Monitor, tighten with a screwdriver. (Screwdriver not included)
Select M4x16 Bolt
M-B
or M5x16 Bolt
M-D
according to your TV/Monitor, connect
VESA Plate
A
together with D5 Washer
M-E
and Spacer
M-F
into the mounting
holes on the back of TV/Monitor, tighten with a screwdriver. (Screwdriver not included)
Flat Back Monitor
Curved Back Monitor
0.8” Height Adjustment
N
A
N
H
F
I
Note:
Please make sure two arms are aligned and balanced.
