Waldorf FNB8120GE, Installation And Operation Manual

Page: 16 / 39

14
Operation
Controller Basic Programming Mode
The following Parameters can be changed in Controller Basic Programming Mode:-
 Timer 1 - Cook Time Settings.

Timer 2 - Cook Time Settings.
 Timer 3 - Cook Time Settings.
 Cooking Temperature Setting.
 Keypad ‘Lock - Unlock’ (Programming the Password Protection).
NOTE:
 Each Timer key on the control panel can be individually programmed with a different
cook time.
 The user cannot enter Basic Programming Mode whilst a timer is running. An alarm
will sound indicating the key press, but access to programming mode will be blocked.
Entering the Controller Basic Settings
1. To enter ‘Programming Mode’, press ‘ON / OFF’ key to turn ‘ON’
the control panel.
2. Press Programme ‘P’ key to access the parameter setting required.
a. If ‘LoC’ is displayed, control panel is locked which will prevent
any accidental change to the operating mode.
b. To access parameters, whilst ‘LoC’ is displayed on screen,
enter the passcode ‘1 1 3 3’.
Setting the Parameters
1. To change the settings, press either or key until the value
required is shown on the display.
2. Press Programme Key ‘P’ to confirm new value and the change will
be accepted. Display will step on to the next parameter.
To Exit the Programming Mode.
To exit Programming Mode, press and hold Programme Key ‘P’ for approximately 3 seconds, or do not
press any key for 2 minutes. Display will revert to ‘Idle Mode’.
TIMER 1
COOK TEMPERATURE
SETTING
KEYPAD
‘LOCK’ - ‘UNLOCK’
Min 0.01
Max 99.59
Min 88
°
C
Max 193
°
C
If set to ‘LoC’, password is required
to change any of these settings.
Password is 1,1,3,3.
TIMER 3
TIMER 2
Min 0.01
Max 99.59
Min 0.01
Max 99.59