21
EN
Operation of vacuuming dusts
1. Make sure the power cord is disconnected from the socket. (Fig1)
2. Loose Clips. (Fig 2)
3. Raise the Head assembly from the dust tank. (Fig 3)
4.
Raise the filter assembly from the dust container. (Fig 4)
5.
Check the filter components are complete: the plastic filter cover (1), Filter core (2)
air-in sponge (3), Hepa assembly (4), then assembly these parts in order (Figure 5)
6.
Put the assembled filter assembly into the dust pan. (Figure 6)
7.
Place the vacuum head assembly on the dust bucket that already has the filter
assembly and lock it with both sides of the buckle. (Figure 7)
8. Align the hose assembly port with the suction port, and then rotate it to the right and
insert it. (Figure 8)
9. Two tube and hose assemblies can be selected. Insert the end of the two tubes with
a large diameter in place (Figure 9).
10. Optional brush and two tube installation. Will be one end of the brush to plug in
place. (Figure 10)
11. Insert the power cord. (Figure 11)
12. Start the switch button. (Figure 12)
13. Start the vacuum. (Figure 13)
