Wahuda 50110CC-WHD, User Manual

Page: 20 / 46

20
ASSEMBLY & ADJUSTMENTS (cont.)
2. To set the 135 degree stop, slightly loosen lever “B” and loosen fence lever “A”. Slide the fence
back completely and re-tighten lever “A”. Place a 45 degree angle against the fence, insert
shims under fence, and use the provided 2.5mm Hex Wrench to adjust the 135 degree set
screw against the stop. NOTE: The set screw is set deep into the angled hole at the factory. If
necessary, use a flashlight to locate it. See FIG 20 and FIG 21. Once adjusted, tighten lever “B”,
remove the shims, and check for 45 degrees. If not at 45, repeat above procedure.
You can now use fence lever “B” to lock the fence at the angle you choose.
NOTE: These positive stops enable you to quickly position the table to the 90 and 135 degree
settings.