fisica
Sensor Case
Thank you for buying the Wahoo Fitness fisica Sensor Case! With fisica technology, a
world of sensor information is opened to your iPhone and scores of Apps are available to
access sensor information in countless ways. Provided here is a quick start guide to using
your fisica Sensor Case - for more information please see our website for more detailed
information and troubleshooting...
www.wahoofitness.com/fisicacaseinfo
Quick Start Guide
Open the fisica Case by unseating each of the six release tabs. Remove cover. Select
and install the approriate rubber cradle for your iPhone, either the iPhone 3G/3GS cradle
or the iPhone 4 cradle (the case comes with the iPhone 4 cradle already installed). Slide
your iPhone into the Case from the top so that the slot at the bottom of the iPhone slides
into the 30-pin connector located at the bottom of the Case. Replace cover and
secure by engaging all six release tabs.
Find Sensors
Each App that incorporates fisica technology uses a unique method to pair with sensors
and you should consult the instructions of the App you are using for the appropriate
pairing technique. If you are having a problem getting your sensor to pair with a
particular App, you can check if the case is working with a particular sensor by using the
fisica Sesnor Utility App. To do this, download the free fisica Sensor Utility App onto your
iPhone from iTunes. Open the App, go to the Sensors tab and select the appropriate
sensor you are trying to find - ensure the sensor is within 5’ of fisica. Your iPhone should
show data from the sensor, the signal strength and the serial number of your sensor.
Since most ANT+ sensors ‘sleep’ when not in use, you may have to ‘awaken’ it - for
example, a stride sensor can be activated by taking a few steps.
Bike Mount
The fisica Case comes with a semi-permanent Bike Mount. The Bike Mount is secured by
threading each of the two Cable Ties through the mounting eyes on the bike mount
(located under the body of the mount) and wrapping around either the handlebars or
the stem, depending on preference. Pull the Cable Ties through their self mating
receivers and pull tight (excess length can be trimmed with scissors). The Bike Mount
can rotate in 90 degree increments by loosening the set screw in the middle of the base,
turning as desired, and re-tightening the set screw.
Auxilliary Battery
Any iPhone compatible auxilliary battery that utilizes a microUSB connector can be used
by plugging the battery into the microUSB port located at the bottom of the Case.
Useability
The Case is designed to be weather and impact resistant. However, Wahoo Fitness does
not warrant against damage to the Case or your iPhone as a result of water, impact or
other factors. It is your responsibility to determine if the Case will provide adequate
protection given the conditions in which it is being used.
3rd Party Sensors
fisica will work with all wireless sensors that conform to the ANT+ standard. However, third
party sensors have not been tested or verified by Wahoo Fitness and the accuracy of
the data produced may not be as precise as those of Wahoo Fitness sensors.
Contact Wahoo Fitness
Feel free to contact Wahoo Fitness for any questions you have regarding your product.
Wahoo Fitness L.L.C.
1604 Athens Hwy
Gainesville, Georgia, USA 30507
AP202
Quick Start
Instructions
WFPeto01
fisica Case
Rear
fisica Case
Front
Back
Bike
Mount
Track
MicroUSB
Port
Headphone
Jack
Rubber Cradle
Bike Mount
Slide Lock
Set Screw
Mounting Eye
For a list of Apps compatible with
the fisica Case, please visit
wahoofitness.com/Apps/Apps.asp
www.wahoofitness.com
