Wahlberg 289.701, User Manual

Page: 13 / 25

289.805.003
13
Date: 2018-11-28
Mode setting
The mode switch is found on the front panel left to the DMX address switches and this can be used
to select various functions and ramps for normal operation, setup and diagnostic purpose.
Mode setting overview
MODE Function Description Note
1 DMX Positioning slow ramp
For normal operation of the Mini Roll Down,
and the slow, medium or fast ramps may be
selected depending on the use and the type of
load. See page 14, 15 and
Figure 1
for details
about the setup and
run.
2 DMX Positioning medium ramp
3 DMX Positioning with fast
ramp
4 DMX Positioning slow ramp
and hard-limits active
For applications where hard-limit switches are
desired, like in situations where the range
needs to be limited by a hardwired switch. The
slow, medium or fast ramps may be selected
depending on the use and the type of load. For more information
about this option see
manual for the DMX
Motor Unit.
5 DMX Positioning medium ramp
and hard-limits active
6 DMX Positioning with fast
ramp and hard-limits active
7 Manual set soft limit top and
bottom position using the
control box Manually set/run to the soft limit top and
bottom positions using the optional control box
(not included), as for stand-alone operation
without DMX.
See page 17 for
details about the
setup and run.
CAUTION! Manual
modes will overrule
any DMX control,
and movement of
the motor may only
be interrupted by
powering off the
mains voltage.
8 Manual run to top and bottom
limits using the control box
9 Manual CW (DMX address =
speed)
Manually setting the motor to a desired
direction and speed via the DMX address
switches, for simple stand-alone operation
without DMX control.
0 Manual CCW (DMX address =
speed)
DMX ADDRESS setting and channel overview
The DMX address, also known as the start channel, is the first channel used to receive instructions
from the controller. For independent control, each Mini Roll Down must be assigned its own
control channels.
The DMX address is configured using the three DMX ADDRESS selectors on the Mini Roll Down.
The selected DMX address states from which channels, on the lighting desk, the Mini Roll
Down is controlled. The Mini Roll Down uses 6 DMX channels. The example below shows a DMX
start address 212 (200+10+2).