7
James Martin Table Blender
Do not operate the appliance continuously for more than 1 minute. Always
allow the appliance to cool down to room temperature before continuing.
WARNING:
ALWAYS COOL HOT LIQUIDS BEFORE BLENDING.
NOTE:
If blending warm liquids remove the measuring cap and start at low
speed increasing to high speed if required. The pulse setting is not
recommended for warm liquids. Do not blend warm liquids over the 1L
level, and always take care to avoid contact with any steam or liquids.
USING THE GRINDING ATTACHMENT
1. Make sure the unit is unplugged and turned off before installation of the
grinder attachment.
2. The grinder can be used for nuts, dried fruit, bread crumbs etc.
3. Turn grinder upside down and carefully unscrew the blade housing.
Carefully remove the housing, blade and rubber seal.
4. Fill the grinder with desired ingredients. Do not fill more than half full.
5. Ensure the rubber seal is in place. See illustration below.
The rubberised seal fits either side of the blade assembly place the
blade onto the glass bowl.
6. Screw the blade housing tightly on to the glass bowl.
7. Turn the grinder the right way up and lock into place on the motor unit
by turning clock wise.
8. Plug the appliance in and select desired speed setting.
9. When the ingredients have been grounded/chopped to the desired
consistency, unplug the appliance, and remove the grinding unit from
the appliance.
NOTE:
Always unplug and remove the complete grinding unit. Do not
unscrew the glass bowl on the unit. As this will cause the ingredients to
spill out and expose the blade unit.
Blade
Rubber Seal
