7
CLIP ‘N’ RINSE
OPERATING INSTRUCTIONS
CHARGING BATTERY ON CLIPPER
Before the appliance is used for the first time, it should be charged for
16 - 18 hours.
1.Connect your transformer into the bottom of your clipper.
2.Plug the transformer into a compatible mains outlet.
3.Ensure that the appliance switch is in the OFF position. The appliance
will only charge when it is switched off. During charging the indicator
light will stay red.
4.Only recharge when the performance noticeably drops. Over charging
will not damage the appliance.
5.When the battery is fully charged the appliance can be used for up to
45 minutes without mains connection.
BATTERY INSTALLATION FOR TRIMMER
1.With the attachment head attached, hold the trimmer head, and
simply slide the bottom compartment downwards to reveal the
battery compartment.
2. Insert the AA Battery negative end first (toward the cutting head).
3. Replace the battery compartment cover
4. Replace the battery as soon as you notice the trimmer running
slower than normal, to avoid pulling of hairs.
USING YOUR PERSONAL TRIMMER
(Not Included in All Wahl Kits)
1.Before trimming remove the protective cap and turn on the
trimmer by pushing the switch up.
2.To trim hair from nose – make sure the nasal passages are clean.
Slowly move the rotary head in and out of each nostril, no more
than a 6mm deep. Keep the side of the cutting head firmly against
the skin to prevent a tickling sensation.
3.To trim hair from ears – make sure the outer areas of the ears do
not contain any wax. Hold the ear flat with one hand and carefully
insert rotary head no more than 6mm into the outer ear. For hair
