17
DE
GB NL FR
Installation
The device should be installed in accordance with the drawing on the first page of the
user manual. Any other installation position may result in serious damage to the device.
Installation should take place as close as possible to a cold water connection. The product
should be protected from the effects of frost (for example in caravans, summer houses,
etc.).
When mounting swivels and squeezed joints, always use 2
open-end spanners in order to prevent bending and twisting
pipes and accessories.
Frost
If there is the risk of frost in a room, the device should not
be installed in this room. If, despite this advice, the device is
installed in a room where there is a risk of frost, the device
should be emptied before the risk arises.
Connection to the water supply
(Illustration 1.)
K = cold water entry side (for filling) blue.
W = hot water exit side (hot water demand) red.
The device is designed for use in pressure systems. This system allows water to be drawn
from a single discharge point.
The connection pipes must be installed as shown in the drawing.
A safety unit must be used for installation.
Installation diagram
(Illustration 1.)
1.
T-piece 15x15x15mm squeezed joint (1)
2. Safety unit 8 bar with funnel (1)
3.
Cross piece with stop 38 x 38 x 38 x 25 (1)
4.
Flexible plastic hose, Ø25mm, 750mm long (1)
5. Hose clamp (1)
6.
Metal braided flexible hose ⅜” x 1/ 2”bi. (1)
7. Metal braided flexible hose ⅜” x 10mm (1)
8. Metal braided flexible hose 15” x 10mm (1)
9.
Fibre washer ⅜” (2)
A. Cold water supply pipe
S. Stop valve of the safety unit
IMPORTANT: In the unlikely event that the device is con-
nected to the mains power supply without being filled with
water, or if for some reason the device switches off after a
short while, please disconnect the plug from the wall socket
to allow the device to cool down.
Summary of Contents for UTS10
Page 2: ...2 e UTS 10 A S 1 2 3...
Page 50: ...50...
Page 51: ...51...
Page 52: ...WB V2 2016 01 WWW WAHLBACH COM...