Quick Start
•
13
Starting up the Bluetooth® Modules
WAGO-I/O-SYSTEM 750
I/O Modules
2.2.2 Configuration of the
Bluetooth
®
Master Using "Net Forming"
1. Start the WAGO-I/O-CHECK software (Version 3 or later).
2. Click on the button
[Identify]
.
Your node configuration is graphically displayed.
3. Click with the right mouse button on the
Bluetooth
®
module that you
would like to configure as a master.
4. Choose
Settings
in the context menu. This opens a new window for the
configuration of the module.
Attention
For the following, the
Bluetooth
®
module must remain intact; i.e., no configu-
ration attempts have been attempted. If this is not the case, click on the
[De-
fault]
, button to reset the module's configuration.
5. Click on
[Data Frame]
in the toolbar.
6. Enter (if not already set) a process image size of 48 bytes and a mailbox
size of 12 bytes (see Figure 7).
Figure 7: Data structure
g064444e
7. Click on the
[Read]
button in the toolbar to update the view of the con-
figuration in the module.
8. In the list on the right side, assign the role of master to the module by
choosing "Master" under
Device Role
.
9. Choose the menu item
Net Forming
in the navigation bar.
