WAGO 765-4102/0100-0000, User Manual

Page: 45 / 146

765-4102/0100-0000 Planning
Product manual | Version: 2.1.0 45
8PORT IOL-B FLD PN DC 24V 2.0A
Table 33: Parameters of the “IO-Link XX I / XX O + PQI” Submodule
Parameter Group Parameters Default Value Range Description
IO-Link port parame-
ters (continued) Validation/backup 0 0: no device check No product check oc-
curs for validation or
backup of connected
IO-Link slave prod-
ucts
1: type-compatible
device (V1.0) A product check for
the indicated device
type is performed for
validation or backup
of connected IO-Link
slave products
2: type-compatible
device (V1.1)
3: type-compatible
V1.1 device with
restore
4: type-compatible
V1.1 device with re-
store
I/Q behavior 1 0: not supported Pin 2 is not used
1: digital input Pin 2 is a digital input
2: digital output Pin 2 is a digital out-
put
5: static on High signal on pin 2
IO-Link port parame-
ters (continued) Port cycle time - 0, 4 ... 191 Port cycle time
0: calculated by IO-
Link master
4 ... 191: see section
8
PROFINET Pa-
rameters [
}
45]
Vendor ID - 0 ... 65535 Manufacturer ID
The manufacturer ID
is used to check
whether an IO-Link
device from the right
manufacturer is con-
nected. For the value
of the manufacturer
ID, see the docu-
mentation of the sen-
sor/actuator used.
Device ID - 0 ... 4294967295 Device ID
The device ID is
checked to see
whether the right IO-
Link device is con-
nected. For the value
of the device ID, see
the documentation of
the sensor/actuator
used.
The “Port cycle time” parameter contains a factor (bits 0 to 5) and a time basis (bits 6+7).
The following table describes how the port cycle time is calculated from the factor and the
time basis.