66
Parameterizing
WAGO-TO-PASS® 761
761-214 Telecontrol Module Compact, 8 AI, ESP, DSP
Manual
Version 2.0.0
7.5.5
Analog Outputs
Select your
TO-PASS
®
telecontrol module from the left side of the project tree
using the identifier. Select the output to be configured under
Analog Outputs
.
The parameters of the output are given on the right side.
The buttons and input fields are identical for all analog outputs:
Figure 29: Configuring the analog outputs
Table 32: Configuring the analog outputs
Standardization
Output Signal
Use these buttons to select the output signal for the actuator
connected to the
TO-PASS
®
telecontrol module.
Min. value
In this field enter the starting value from which the output
value is normalized. This value corresponds to the minimum
output current value of 0 mA or 4 mA.
Max. value
In this field enter the end value up to which the output value
is normalized. This value corresponds to the maximum output
current 20 mA.
Unit
In this field enter the unit with a maximum of 5 characters
with which the normalized process value is to be transmitted.
Set output
Text
In this field enter the text for setting the output.
If this text is transmitted with a value situated within the min.
and max. value, the
TO-PASS
®
telecontrol module sets the
analog output to the specified value.
