WAGO 2787-2144, Product Manual

Page: 6 / 68

2787-2144 Provisions
6 Product manual | Version: 1.0.0
Power Supply Pro 2
1 Provisions
This documentation applies to the WAGO Power Supply Pro 2 (2787-2144).
Note
Observe the applicable documentation!
This product must only be installed and operated according to the instructions of the com-
plete Instructions for use. Knowledge of the complete Instructions for use is required for
proper use.
1. Carefully read the Product Manual.
2. Before commissioning, follow the instructions in section
8
Safety [
}
10] .
Table 1: Complete instructions for use
Document Type Contents
& Product Manual Contains all the product-specific information for a product.
&
Instruction leaflet Is included with each product. Contains initial information on safe handling of
the product.
All the documentation is available at:
ü
www.wago.com .
1.1 Intended Use
The 2787 Series WAGO Power Supply Pro 2 provides DC voltage to electrical or elec-
tronic devices, such as industrial control systems or display, communication and measur-
ing devices.
The product is an open system and is designed for installation in a additional enclosure.
• This product fulfills the requirements of protection type IP20 and is designed for use in
dry indoor spaces.
• Operation of the products in Industrial area is permitted.
• The product meets the EMC requirements for Residential, businesses and commercial
areas; small businesses too. if the product used complies with the emission of interfer-
ence requirements (emission limits).
• Operation of the product in other application areas is only permitted when correspond-
ing approvals and labeling are present.
Improper Use
Improper use of the product is not permitted. Improper use occurs especially in the follow-
ing cases:
• Non-observance of the intended use.
• Use without additional protective measures in environments within which dust, corro-
sive fumes, gases or ionized radiation can occur.
• Use of the product in areas with special risk that require continuous fault-free operation
and in which failure of or operation of the product can result in an imminent risk to life,
limb or health or cause serious damage to property or the environment (such as the
operation of nuclear power plants, weapons systems, aircraft and motor vehicles).