WAGNER WallPerfect W 625 I-Spray, Manual, Page: 37 / 74

29
WallPerfect W 625 I-Spray GB
Problem Cause Remedy
Spray jet pulsates Coating material in
•
container running out
Nozzle seal worn
•
Air filter heavily soiled
•
Refill
➞
Replace
➞
Change
➞
Coating material
causes "paint tears"
Too much coating material
•
applied
Viscosity of coating material
•
too low
Turn material volume
➞
adjusting screw to the left (-)
Too much fog of
coating material
(Overspray)
Distance to the object too
•
large
Too much coating material
•
applied
Reduce distance
➞
Turn material volume
➞
adjusting screw to the left (-)
Device does not
function
Device overheated
•
Unplug the power plug,
➞
let the device cool down
approx. 30 minutes, do not
bend the hose, check the
air filter, do not cover the
intake slots
Paint in the
ventilating hose
Diaphragm soiled
•
Diaphragm defective
•
Clean the diaphragm
➞
Replace the diaphragm
➞
Poor covering
capacity on the wall
Spray material is too cold
•
Highly absorbent surface
•
or paint with poor covering
capacity
Distance too large
•
Heat spray material
➞
(to
maximum 40°C
)
Cross spray (Fig. 11)
➞
Closer to the object
➞
Warning
If the supply cord of this appliance is
damaged, it must only be replaced by a
repair shop appointed by the manufacturer,
because special purpose tools are
required.
Warning:
Do not connect the blue
or brown wire to the earth
terminal of the plug! The
wires in this mains lead are
coloured in accordance with
the following code:
blue
= neutral
brown
= live