GB
34
W 690 Flexio
Malfunction
Cause
Remedy
Atomisation too
coarse
•
Material volume too large
Material volume adjusting screw
turned too far to the right (+)
•
Nozzle contaminated
•
Viscosity of coating material too
high
•
Too little pressure build-up in
container
•
Air filter heavily soiled
•
Amount of air too low
➞
Turn material volume
adjusting screw to the
left (-)
➞
Clean
➞
Dilute further
➞
Tighten container
➞
Change
➞
Turn the air volume
control to the left (+)
Spray jet pulsates
•
Coating material in container
running out
•
Nozzle seal worn
•
Air filter heavily soiled
➞
Refill
➞
Replace
➞
Change
Coating material
causes "paint
tears"
•
Too much coating material applied.
➞
Turn material volume
adjusting screw to the
right (-)
Too much fog of
coating material
(Overspray)
•
Distance to the object too large
•
Too much coating material applied
•
Amount of air too high
➞
Reduce distance
➞
Turn material volume
adjusting screw to the
left (-)
➞
Turn the air volume
control to the left (-)
Width of paint
spray cannot be
adjusted
•
Adjustment ring is not connected
to the peg on the air cap
•
Air screen is clogged up
➞
Connect adjustment
ring and peg
➞
Disassemble and clean
Paint in the
ventilating hose
•
Diaphragm soiled
•
Diaphragm defective
➞
Clean the diaphragm
➞
Replace the diaphragm
Poor covering
capacity on the
wall
•
Spray material is too cold
•
Highly absorbent surface or paint
with poor covering capacity
•
Distance too large
➞
The material you are
spraying should be at
room temperature
➞
Cross spray (Fig. 13)
➞
Closer to the object
Summary of Contents for W 690 Flexio
