7
VM 5000
OPERATING MANUAL
EDITION 07/2014
ORDER NUMBER DOC 2344501
2
CORRECT USE
2.1
DEVICE TYPE
2.2
TYPE OF USE
WAGNER's electrostatic control unit VM 5000 controls and regulates the high-voltage
supply to the GM 5000EA or GM 5000EAC spray guns used to apply liquid coating media
and the high-voltage Universal cascade.
The VM 5000 may only be operated together with the above-mentioned manual spray
guns or the high-voltage Universal cascade. If the control unit is operated in combination
with devices other than the above-mentioned spray guns, the FM authorizations (type
approvals) cease to be valid.
These electrostatic manual spray guns are suitable for spraying liquid products, in particular
coating products that follow AirCoat or Airspray techniques. Coating products containing
solvents of explosion class II A may be used.
Control unit for controlling GM 5000EA or GM 5000EAC electrostatic spray guns and the
high-voltage Universal cascade.
Incorrect use!
Risk of injury and equipment damage.
Only connect original Wagner spray guns or the high-voltage
Universal cascade to the VM 5000 control unit.
Only connect the GM 5000EA, GM 5000EAC spray guns or the
high-voltage Universal cascade.
WARNING
2.3
SAFETY PARAMETERS
The control unit is only suitable for controlling spray guns and the Wagner high-voltage
Universal cascade. J. Wagner AG forbids any other use!
The control unit may only be operated under the following conditions:
The operating staff have previously been trained on the basis of this operating manual.
The safety regulations listed in this operating manual must be observed.
The operating, maintenance, and repair information in this operating manual must be
observed.
The statutory requirements and accident prevention regulation standards in the country of use
must be observed.
The control unit may only be operated if all parameters are set and all measurements / safety
checks are carried out correctly.
