125
VERSION 10/2018
ORDER NUMBER DOC 2339321
.
14 SPARE PARTS
WARNING
Incorrect maintenance/repair!
Danger to life and equipment damage.
Only a WAGNER service center or a suitably trained person may carry out repairs and
replace parts.
Use only WAGNER original spare parts and accessories.
Only repair and replace parts that are listed in the "Spare parts" chapter and that are
assigned to the unit.
Before all work on the device and in the event of work interruptions:
− Switch off the energy and compressed air supply.
− Relieve pressure from spray guns, high-pressure hoses and all devices.
− Secure spray guns against actuation.
− Disconnect the control unit from the mains.
Observe the operating and service manual for all work.
14.1 WHERE CAN SPARE PARTS BE FOUND?
Spare parts for the TwinControl systems and the TwinControl accessories are to be found
in the following spare parts catalogs (German and English):
–
Finishing spare parts catalog
for systems with a small frame / small trolley / small wall.
–
PC spare parts catalog
for systems with a large frame / large trolley.
– Further spare parts for TwinControl components, which are not contained in the spare
parts catalog, can be found on the
compact disk (CD) TwinControl
in the appropriate
operating manuals, in all languages available.
Order no., see Chapter
14.2 SERIAL NUMBER
The parameters used by WAGNER and the special properties
of each 2K TwinControl system are documented upon
delivery and stored in the WAGNER archive.
If the customer wishes to modify the 2K TwinControl system
or prior to inspections, the technical customer service team
must always be provided with the serial number of the
system in question. The serial number can be found on the
rear side of the control unit.
B
A
7
11
12
22
21
24
25
5
3-
2-
1-
1
2
3
4
6
10
8-
8
9
Year of construction /
Baujahr:
Serial No. controller:
Serie Nr. Steuerung:
Air pressure supply:
Luftdruckversorgung:
IP Code:
Schutzart:
IP 54
Ambient temperature:
Temperatur Umgebung:
0.6 - 0.8 MPa
6 - 8 bar
87 - 116 psi
+5 / +40 °C
+5°C < Ta < +40°C
II 2 G
Ex ia II B T4
ZELM 08 ATEX 0385 X
+5°C < Ta < +40°C
0102
Check manual before use!
Vor Gebrauch Betriebsanleitung
beachten!
CH 9450 Altstätten
TwinControl
Made in Switzerland
Type /
Typ:
Wagner International AG
Serial No unit:
Serie Nr. Anlage:
B_03752
14.3 TURBINE
When replacing the turbine, attention should be paid to the "TC Turbine Set" assembly
manual with order no. 2320883.
When replacing the generator, attention should be paid to the
"TC Generator Conversion Set" assembly manual with order no. 2336796.
