WAGNER Tribo PEA-T3, Operating Manual

Page: 15 / 32

Maintenance and cleaning
03/2008
351874
- PEA-T3
15
4.2 Cleaning the spray gun and replace the wear parts
Caution
Never place the spray gun or parts of it into any wet cleaning agent!
While pulling out and replacing the wearing parts make sure that the parts of the
charging body are not damaged!
4.2.1 Replacing the charging body
0402_Peat3_Verschleiss.doc
A
2
20/32
B
L
25
Peat3_0005b

Pull the deflector cone A off the charging
body L .

Unscrew the outer nut 2 from the gun
housing B .

Pull the nozzle body 20/32 off the powder
tube 25 .

Carefully extract the charging body L out
of the powder tube 25 .

Check the removed parts for wear. The
entire
charging body can be replaced
with a new one during this procedure.
0402_Peat_Verschleiss.doc
It is also possible to dismantle the charging body and merely replace the parts affected by
wear.
28
26
23
24
16
18
22
Peat3_0005c

Unscrew the tip 28 from the threaded
bar 22 .

Carefully pull the parts 24 to 26 off the
threaded rod 22 .

As a rule you only need to check the
parts 24 to 26 for wear and replace
them as necessary.

Clean all parts that have not been
subject to wear.

Unscrew the air nozzle 16 from the
deflector cone rod 18 if worn and
replace it with a new one.

Reassemble the charging body L and
carefully push it into powder tube 25 .

Carefully push the nozzle body 20/32 over the powder tube 25 and tighten on the gun
housing B using the outer nut 2 .

Slide the deflector cone A back over the charging body L .