English
© Wagner Spray Tech - All Rights Reserved
3
Important Safety Information
9. Keep spray area well ventilated. Keep a good
supply of fresh air moving through the area
to keep the air within the spray area free from
accumulation of flammable vapors. Keep
turbine assembly in well ventilated area. Do not
spray turbine assembly.
10. Do not smoke in the spray area.
11. Do not operate light switches, engines, or
similar spark producing products in the spray
area.
12. Keep area clean and free of paint or solvent
containers, rags, and other flammable materials.
13. Know the contents of the paint and solvents
being sprayed. Read all Material Safety Data
Sheets (MSDS) and container labels provided
with the paints and solvents. Follow the paint
and solvent manufacture’s safety instructions.
14. Do not use any coating materials containing
Halogenated Hydrocarbon (HHC) such as bleach
or chlorine.
15. Fire extinguisher equipment shall be present
and working.
16. Do not spray the device.
WaRnInG - To reduce the risk of
injury:
1. Always wear appropriate gloves, eye protection,
clothing and a respirator or mask when
painting. Hazardous vapors – Paints, solvents,
insecticides, and other materials can be harmful
if inhaled or come in contact with body. Vapors
can cause severe nausea, fainting or poisoning.
2. Do not operate or spray near children. Keep
children away from equipment at all times. Do
not allow unauthorized use of the device.
3. Do not overreach or stand on an unstable
support. Keep effective footing and balance at
all times.
4. Stay alert and watch what you are doing.
5. Do not operate the unit when fatigued or under
the influence of drugs or alcohol.
6. Never aim spray gun at any part of the body.
Do not point the spray gun at other persons or
animals.
7. Follow all appropriate local, state, and national
codes governing ventilation, fire prevention,
and operation.
8. The United States Government Safety Standards
have been adopted under the Occupational
Safety and Health Act (OSHA). These standards,
particularly part 1910 of the General Standards
and part 1926 of the Construction Standards
should be consulted.
9. Use only manufacturer authorized parts. User
assumes all risks and liabilities when using parts
that do not meet the minimum specifications
and safety devices of the turbine manufacturer.
10. Power cord must be connected to a grounded
circuit.
11. Do not spray outdoors on windy days.
12. Use only Wagner HVLP hose.
13. Do not use the air hose or power cord to move
the device.
WaRnInG - To reduce the risk of
electric shock:
1. Power cord must be connected to a grounded
circuit.
2. Never submerge electrical parts.
3. Never expose the equipment to rain. Store
indoors.
4. Keep electrical cord plug and spray gun trigger
free from paint and other liquids. Never hold
the cord at plug connections to support the
cord. Failure to observe may result in an
electrical shock.
5. Avoid spraying in humid conditions. If the
operation of the unit in a humid environment
cannot be avoided, use a residual circuit
breaker. The use of a residual circuit breaker
prevents the risk of electric shock.
Important Electrical
Information
Use only a 3-wire extension cord that has a 3-blade
grounding plug and a 3-slot receptacle that will
accept the plug on the product. Make sure your
extension cord is in good condition.
When using an extension cord, be sure to use one
heavy enough to carry the current your product will
draw. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating.
A 14 gauge or 12 gauge cord is recommended.
If an extension cord is to be used outdoors, it must
be marked with the suffix W-A after the cord type
designation. For example, a designation of SJTW-A
would indicate that the cord would be appropriate
for outdoor use.
