WAGNER GA 5000EAEC, Translation Of The Original Operating Manual

Page: 67 / 108

67
GA 5000EA
OPERATING MANUAL
VERSION 09/2016 ORDER NUMBER DOC2360924
Functional fault Cause Remedy
Insuffi cient product output Nozzle too small Select larger nozzle
(see "Accessories" chapter).
Product pressure too low Increase product pressure.
Product pressure generator blocked Clean or replace fi lter.
Nozzle is clogged
Clean or replace nozzle.
Product valve travel set too small Increase product valve travel by turning
the adjusting screw.
Poor spray pattern Wrongly adjusted atomizing air Readjust the atomizing air.
Unfavorable nozzle size Select a diff erent nozzle
(see "Accessories" chapter).
Product pressure too high/too low Adapt product pressure.
Spray product viscosity too high Thin product in accordance with the
manufacturer's instructions.
Damaged nozzle Attach new nozzle.
Poor wrap-around Poor grounding at object Check grounding of object or hanger
with ohmmeter.
Air pressure too high Reduce air pressure
Lacquer resistance too high/too low Check lacquer resistance
(see Chapter 2.5).
Spraying pressure too high Readjust spraying pressure.
No wrap-around No high voltage Switch on high voltage at the control
unit. / Repair malfunction as explained
in the control unit operating manuals.
Connect gun and gun cable/check for
defect.
Check lacquer resistance
(see Chapter 2.5).
Seal in end piece defective Repair by WAGNER Service Department.
Air-passages damp Clean and dry air passages.
Back-spray Poor grounding at object Check grounding.
Distance between spray gun and
object too large Reduce distance between spray gun
and work piece.
High voltage set wrongly (too high) Adapt high voltage to product.
Loosen the nozzle union nut for
round jet method
Tighten union nut by hand.
Valve seat leaks Valve seat or valve tip worn Replace valve seat or valve tip.
9
TROUBLE SHOOTING AND RECTIFICATION