SmartSound FM/USB/Charger by Wagan Tech
USER’S MANUAL — Please read before using this equipment.
________________________________________________________________________________________________________________________________________________________________
www.wagan.com
© 2007 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
2
Thank you for purchasing the SmartSound FM/USB/Charger by Wagan
Tech. With normal care and proper treatment it will provide years of
reliable use. Please read all operating instructions carefully before use.
CHARGING BATTERIES
1.
Open the battery cover of your SmartSound FM/USB/Charger.
Install the AAA rechargeable batteries and close the battery cover.
Make sure you only insert rechargeable batteries.
2.
Plug your device to the cigarette lighter port in your car. The
batteries will start charging.
3.
After the batteries have been fully charged by the car batteries
(normally it takes about 8 hours) you may take your SmartSound
FM/USB/Charger out of the car and use it where you wish
CAUTION:
•
Do not put non-rechargable batteries into the SmartSound
FM/USB/Charger while plugging it into the cigarette lighter
port.
•
Attempting to charge non-rechargable batteries may cause an
explosion.
FM TRANSMITTER
1.
Plug one end of the 3.5mm connector into your SmartSound
FM/USB/Charger and the other end into your MP3 player or other
portable music device.
2.
Turn on the SmartSound FM/USB/Charger by pressing and holding the
ON/OFF
button for at least 5 seconds. You can then select the next
frequency by pressing the
ON/OFF
button briefly once. To turn off your
SmartSound FM/USB/Charger, press and hold the
ON/OFF
button for at
least 5 seconds.
3.
Turn on your FM radio and tune it to the matching frequency of the
SmartSound FM/USB/Charger.
4.
Adjust the volume of your MP3 player or other audio source to a medium
level.
5.
Adjust the volume of your FM radio to the desired audio level.
FCC CAUTION:
Changes or modifications to this unit not expressly approved by the party responsible for compliance will void the user’s
authority to operate the equipment. Any change to the equipment will void FCC grant.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
All other devices shall bear the following statement in a conspicuous location on the device: This device complies with Part 15 of
the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and(2)this
device must accept any interference received, including interference that may cause undesired operation.
