www.wagan.com
8
Elite 400W Pure Sine Inverter by Wagan Tech
©2010 Wagan Corporation
All Rights Reserved
Wagan and wagan.com are trademarks used by Wagan Corporation
Battery Clip Adapter Cord – Up to 400 Watts Output
1. Connect just the red spade terminal of the supplied DC Battery Clip Adapter
Cord to the red stud terminal (+) on the rear of the inverter.
2. Connect the two battery clips to the battery.
Be sure to connect the clips to the correct polarity battery terminals. Reverse
polarity connection will blow the fuse in the inverter and can permanently
damage to the inverter. Damage caused by reverse polarity will void the
warranty.
3. Connect the Negative black (−) spade connector to the stud connector
on the rear of the inverter. There may be a momentary spark and the low
voltage buzzer may briefly sound.
4. Plug the AC appliance cord into the inverter’s AC receptacle, and/or your
USB appliance into the USB Power Port.
5. Place the ON/OFF power switch in the ON position. The green LED should
turn on, indicating the inverter is powered and operating normally.
6. While the Inverter is not in use, place the inverter’s ON/OFF Power Switch to
the OFF position.
Battery Clip
Adapter Cord
DC Plug Adapter
Cord
