User’s Manual—Please read before using this equipment.
© 2008 Wagan Corporation.
All Rights Reserved.
Wagan and wagan.com are trademarks used by Wagan Corporation.
Troubleshooting
Problem
Possible Causes
Remedy
Lack of power output
Power center voltage below
12 volt.
Recharge the Power Center
immediately.
Excessive current drawn by
appliance being operated
Reduce load to maximum
200 watts.
Inverter not adequately
warmed up.
Turn off the device and
inverter. Disconnect the
device. Turn the inverter on
for a minimum of 2 minutes.
Turn off inverter, quickly
plug in the device to the
inverter, making sure the
device is off prior to con-
nection. Turn on the inverter
and the device.
Inverter fuse blown.
Replace a new 25 AMP
rated fuse. To replace fuse:
remove fuse with needle
nose pliers and replace with
a new 25 AMP fuse.
LED light fails to activate
Inadequate power or exces-
sive voltage drop.
Check Power Dome LT,
recharge if voltage drops
below 12 Volts
Inverter is overloaded.
Replace load to a max of
200 watts.
Television/Power Tool will
not start
High surge wattage require-
ment to start-up.
Toggle the Master On/Off
switch in quick succession
5 times in order to generate
the necessary power to start
the device. If the device
does not start up in 5 cycles
of ON/OFF trials, this
inverter will not work with
the device.
Television picture breaking
up (snow).
Television Interference
Move the Power Dome LT
as far as possible from TV,
the antenna and the coaxial
cable.
TV station may be out or
range.
Summary of Contents for 2464
Page 1: ...Item no 2464 Article no 2464 User s Manual Guide d Utilisation Power Dome LT R ...
Page 2: ......
Page 10: ......
