EN
Cleaning and care
TC07DC
18
6.3
Switching between cooling and heating
➤
If you wish to switch between
cooling
and
heating
, push the switch
on the operating panel (see fig.
2
C, page 3) into the “HEISS/HOT”
or “KALT/COLD” position.
✓
The red or green operating display lights up and the device begins cool-
ing/heating.
➤
If you wish to end the cooling/heating process, push the switch on the op-
erating panel (see fig.
2
C, page 3) into the “AUS/OFF” position.
➤
If you wish to switch off the device, pull out the connecting cable.
6.4
Connecting to a cigarette lighter
I
7
Cleaning and care
!
A
➤
Occasionally clean the device interior and exterior with a damp cloth.
➤
Make sure that the air inlet and outlet vents on the device are free of any
dust and dirt, so that heat can be released and the device is not damaged.
NOTE
If you connect the device to the cigarette lighter of your vehicle
(see fig.
3
, page 3), remember that the ignition must be turned
on to supply the device with power.
WARNING!
Always disconnect the device from the mains before you clean
and service it.
NOTICE! Risk of damage
Never clean the cooler under running water or in dish water.
Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooler.
