Waeco RV-AMP/4, Installation And Operating Manual

Page: 26 / 124

Installation and connection PerfectView Accessory
26
6 Installation and connection
6.1 Tools required
For installation and assembly you require the following tools:
z Measuring ruler (see fig. 3.4, page 4)
z Centre punch (see fig. 3.5, page 4)
z Hammer (see fig. 3.6, page 4)
z Drill bit set (see fig. 3.7, page 4)
z Drill (see fig. 3.8, page 4)
z Screwdriver (see fig. 3.9, page 4)
For making and testing the electrical connection the following tools are required:
z Diode test lamp (see fig. 3.1, page 4) or voltmeter (see fig. 3.2, page 4)
z Insulating tape
z Heat shrinking sleeve
z Hot air blower (see fig. 3.10, page 4)
z Crimping tool (see fig. 3.11, page 4)
z Soldering iron, if required (see fig. 3.12, page 4)
z Solder, if required (see fig. 3.13, page 4)
z Cable bushing sleeves, if required
6.2 Installing and connecting the control box
The control box is supplied ready for installation.
➤ Install the control box in a location protected from water near the monitor, prefera-
bly under the dashboard.
Make sure to consider the length of the cable.
➤
Attach the control box using the supplied screws.
➤ Insert the plug and the cable set in the connection provided (12 - 24V) on the switch
box.
➤
Connect the brown cable (see fig. 5.1, page 6) to earth.
➤ Connect the red cable (see fig. 5.2, page 6) to an active positive line (such as termi-
nal 15).
Warning!
Ensure that you connect the control cables correctly to + PLUS an not to
earth. Connecting the control cables to earth can damage the device.
➤ Connect the green cable (see fig. 5.5, page 6) to the positive cable of the reversing
light.
RV-AMP4.book Seite 26 Dienstag, 31. Oktober 2006 4:20 16