PerfectView
Safety and installation instructions
19
When the negative terminal of the battery is disconnected, all data stored in the volatile
memory will be lost.
z
The following data must be set again, depending on the vehicle equipment options:
– radio code
– vehicle clock
– timer
– on-board computer
– seat position
You can find instructions for making these settings in the appropriate operating
instructions.
Observe the following installation instructions:
z
Secure the parts of the camera installed in the vehicle in such a way that they cannot
become loose under any circumstances (sudden braking, accidents) and cause
inju-
ries to the occupants
of the vehicle.
z
Secure any parts of the system covered by the bodywork in such a manner that they
cannot be come loose or damage other parts and cables and impair vehicle functions
(steering, pedals, etc).
z
To prevent damage, when drilling ensure that there is sufficient space on the other
side for the drill head to come out (fig.
1
, page 3).
z
Deburr all drill holes and treat them with a rust-protection agent.
z
Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only be per-
formed by qualified specialists.
Observe the following instructions when working with electrical parts:
z
Only use a diode test lamp or voltmeter to test voltages in electric cables.
Test lamps with an illuminant consume voltages which are too high and which can
damage the vehicle’s electronic system.
z
When making electrical connections, ensure that
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection (fig.
2
, page 3).
z
Insulate all connections.
z
Secure the cables against mechanical wear with cable binders or insulating tape,
for example to existing cables.
CAM30_CAM40.book Seite 19 Donnerstag, 14. Januar 2010 5:32 17
