Waeco PerfectPower PP402, Installation And Operating Manual

Page: 22 / 172

EN
Connecting the inverter
PerfectPower
22
 The inverter may not be installed in the presence of flammable materials.
 The inverter may not be installed in a dusty environment.
 The place of installation must be well-ventilated. A ventilation system
must be present for installations in small, enclosed spaces. The clearance
around the inverter must be at least 25 cm (fig.
4 , page 4).
 The air intake on the underside or the air outlet on the back of the inverter
must remain clear.
 For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the inverter under load
can lead to the automatic shut-off of the inverter.
 The installation surface must be level and sufficiently sturdy.
A
NOTICE!
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
Fasten the inverter as follows (fig. 5 , page 4):
➤
Clip two holders on the lower left bar and two on the right.
You can move the holders as required.
➤
Fasten the inverter by screwing one screw through each hole in the hold-
ers.
6.2 Connecting the PP152 and PP154
!
WARNING!
The rating of the vehicle socket, the supply cable, and the fuse
must be at least 15 amps. Do not put in a fuse with a higher rating.
A
NOTICE!
Make sure that the plug is firmly connected in the vehicle socket. If
the connection is loose, the plug may heat up.
The connection is made via a plug that is connected to a 12 V vehicle socket
(for PP152) and a 24 V vehicle socket (for PP154). The middle pin of the plug
(fig.
1 4, page 2) must be connected to the positive wire and the two side
brackets of the plug (fig. 1 5, page 2) must be connected to the negative
wire.
_PP150_PP400_PP600.book Seite 22 Montag, 7. Mai 2012 9:45 09