7
Delivery kit
Operation of the switch-mode rectifiers is done
by the ON/OFF switch. In case you switch the
inverter ”ON” the green control LED signals
operation.
In case battery voltage falls below 10.5 V for
720-012PP or 21.0 V for 720-024PP during
operating mode, an acoustic warning signal
is given and the colour of the control LED
changes from green to yellow.
In case the inverter is heated up too seriously,
it switches off automatically and the colour of
the control LED changes from green to yellow.
Switch the inverter off manually. After the
inverter has cooled down, you can switch it on
again.
When running the Pocket Power for a long time
and with maximum load, it is recommendable
to start the engine of the vehicle so to prevent
the vehicles battery getting discharged.
The Pocket Power may be used either while
the engine is running or turned off. However,
do not start the engine with the Pocket Power
in use. The voltage to the lighter plug may shut
off during cranking.
No.
Pieces
Description
Ref. No.
1
1
Pure sine wave inverter with connection wire
720-012PP/720-024PP
2
1
Instruction manual
Installation
Connection is made via a plug which suites
into a 12 V cigarette lighter socket. The pin
in the middle of the plug is connected to
the (+) plus cable and the bows at the edges
of the plug are connected to the (-) minus
cable.
Take care that a firm connection is made
when plugging in. In case the plug is not
put in correctly, the plug will heat up.
1
230 V AC Output
2
ON/OFF Controll-LED
3
ON/OFF Switch
4
Minus-contakt
5
Plus-contakt
Attention!
The cigarette lighter socket, the
cables and the fuse do have to suit to a current
of at least 15 A. Don’t change type or ranking
of fuse!
Operating the inverter
1
5
4
3
2
