MagicWatch MWE250
Installing MagicWatch
33
Caution!
As these four examples show, situations can arise where the
device fails to display an object or does not display the shortest
distance.
The device does
not
relieve you of your obligation to
take special
care when reversing
. Therefore, always be extremely careful
when reversing.
If an object enters the blind spot of the sensors, MagicWatch auto-
matically shows the distance to the next object. This means the pie-
zoelectronic speaker changes from fast to medium beeps.
In this case, always stop the vehicle immediately and check the sit-
uation.
6
Installing MagicWatch
6.1
Tools required
For
installation and assembly
you require the following tools:
z
Drill bit set (see fig. 1.1, page 3)
z
Drill (see fig. 1.2, page 3)
z
Screwdriver (see fig. 1.3, page 3)
z
Set of ring or open-ended spanners (see fig. 1.4, page 3)
For making and testing the
electrical connection
the following tools are
required:
z
Diode test lamp (see fig. 1.5, page 3) or Voltmeter (see fig. 1.6, page 3)
z
Crimping tool (see fig. 1.7, page 3)
z
Insulating tape (see fig. 1.8, page 3)
z
Cable bushing sleeves, if required
To
secure the controller and the cable
you may require additional screws
and cable binders.
MWE-250-3.book Seite 33 Dienstag, 28. März 2006 4:50 16
Summary of Contents for MagicWatch MWE250
Page 3: ...MagicWatch MWE250 3 1 2 3 4 9 6 8 5 7 1 MWE 250 3 book Seite 3 Dienstag 28 M rz 2006 4 50 16...
Page 4: ...MagicWatch MWE250 4 2 3 1 5 4 4 2 3 MWE 250 3 book Seite 4 Dienstag 28 M rz 2006 4 50 16...
Page 7: ...MagicWatch MWE250 7 13 14 MWE 250 3 book Seite 7 Dienstag 28 M rz 2006 4 50 16...
