MAGIC CONTROL
Safety and installation instructions
51
Observe the following instructions when working with electrical parts:
z
When testing the voltage in electrical cables, only use a diode test lamp
(
1
8, page 3) or a voltmeter (
1
9, page 3).
Test lamps with an illuminant (
1
12, page 3) take up voltages which are
too high and which can damage the vehicle's electronic system.
z
When making electrical connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection (
3
, page 4).
z
Insulate all connections.
z
Secure the cables against mechanical wear with cable binders or
insulating tape, for example to existing cables.
Observe the following instructions during use:
z
MAGIC CONTROL does not take any corrective action. It is the sole
responsibility of the driver to correct the tyre pressure at the earliest
possible juncture.
z
MAGIC CONTROL cannot detect sudden bursting of the tyre or other
defects and warn the driver in time.
z
MAGIC CONTROL does not monitor any properties other than tyre
pressure and temperature, for example wear.
z
The driver should check that a self-test is performed each time the ignition
is switched on.
MTPM-100.book Seite 51 Freitag, 15. Juli 2005 4:37 16
Summary of Contents for MAGIC Control MTPM-100
